Compact Finger Joint Machine CFC30
—
Location: Products
Back to Home
Equipment Introduction:
Voll automatic production: finger shapping/glue appilication/pressing and length cutting programed without any manell operation.
Leightly Curved or twisted raw material is allowed to be finger jointed, no pre-planing and short cutting is needed – time and timber saving.
3 to 4 workers can be reduced, the production area required is up to 80% less, the volume of glue consumption is reduced up to 60%.
Parameters:
Length of feeding material: min 1,500 mm
Thickness of material: 20 mm - 65 mm
Width of material: 75 mm - 300 mm
Length of out feeding material: ≥ 3,000 mm
Processing frequency:4 cycles/minute
Glue type:PUR(one component) or two components glue